Deep Hole Vac-u-Gun

Deep Hole Vac-u-Gun

Deep Hole Vac-u-Gun

PDF
rvd certificate

Blow chips loose and vacuum them away in one step! Ideal for cleaning cavities and drilled holes!

Image

What Is The Deep Hole Vac-u-Gun?

A low cost solution to quickly removing chips and contaminants from grooves, containers and drilled holes. The Deep Hole Vac-u-Gun replaces dangerous blow guns that can cause chips or debris to fly in all directions. Simply position the Deep Hole Vac-u-Gun over the hole and press the trigger. A small blow tube dislodges and lifts the chips while the large suction tube vacuums them away. The operator is protected from flying debris since all contaminants are contained within the clear suction tube. It is perfect for cleaning holes up to 1-1/4" (32mm) diameter at a depth of 18" (457mm).
Image
Image
Image

Why The Deep Hole Vac-u-Gun?

The Deep Hole Vac-u-Gun uses less compressed air than an ordinary blow gun. It injects a small amount of compressed air through directed nozzles to produce a vacuum on one end and a high output flow on the other. The amplified output flow is 12 times the air consumption rate. Lightweight and easy to use, the Deep Hole Vac-u-Gun has a durable die cast construction with no moving parts to wear out. A hanger is provided for easy storage or for mounting on a tool balancer.

Applications

  • Holes in fixtures
  • Drilled plastics
  • T-Slots -- groove cleaning
  • Woodworking
  • Bottle cleaning
  • Container Cleaning
  • Tapped holes
  • Cupped surfaces
  • Punch press tables
  • Cavity evacuation
  • Coolant evacuation from parts

Advantages

  • No moving parts
  • Low cost
  • Durable - die cast construction
  • Eliminates shock hazard - No electricity
  • Low air consumption
  • Safe Operation - No flying chips
  • Lightweight and portable
  • Quiet
  • Meets OSHA pressure and chip guard requirements

How The Deep Hole Vac-u-Gun Works

Compressed air, normally 80-100 PSlG (5.5 - 6.9 BAR), flows through the inlet (1) into an annular plenum chamber (2) when the trigger is depressed. A small amount of air is injected into the blow tube (3) to provide lift for the chips or debris. The larger airflow is injected into the throat of the gun through directed nozzles (4). These jets of air create a vacuum at the intake (5) which draws material in and accelerates it through the unit. The chips, debris or other particulate can then be exhausted into a filter bag or hose attached to the Deep Hole Vac-u-Gun System.
The Deep Hole Vac-u-Gun should not be operated without a filter bag or vacuum hose attached to the exhaust. Vacuum tools can not be used with this product.
Image
Image
Image